Hopkinsi 43105 pistikühendusega lihtne sõiduki juhtmestiku komplekt

Brand:‎Hopkins Towing Solutions

3.6/5

66.32

Hopkins Towing Solutions, mis on pukseerimiselektritoodete kaubamärk number üks, on pakkunud tarbijatele uuendusi, vastupidavust ja jõudlust juba üle kahekümne aasta. Hopkinsi T-konnektoritega ei pea te oma sõiduki juhtmestikku lõikama. See on kiirem ja lihtsam kui lõikamine ja splaissimine ning hoiab teie sõiduki juhtmestiku terviklikkuse puutumatuna.

Ei mingit lõikamist, jootmist ega teipimist. Lihtne 4-astmeline paigaldus. Kaheosaline süsteem pakub mitmekülgsemat paigaldust ja lihtsat pistiku vahetamise võimalust, kui seade peaks kunagi viga saama. Eeljuhtmega, et pakkuda parempööret, vasakpööret, tagatulesid ja mõnel mudelil varufunktsiooni. T-konnektorid võimaldavad ühendada haagise juhtmestiku sõiduki juhtmestikuga.
Brand ‎Hopkins Towing Solutions
Country of Origin ‎USA
Customer Reviews 4.6 4.6 out of 5 stars 287 ratings 4.6 out of 5 stars
Exterior ‎Smooth
Is Discontinued By Manufacturer ‎No
Item model number ‎43105
Item Weight ‎7.2 ounces
Manufacturer ‎Hopkins Towing Solution
Manufacturer Part Number ‎43105
OEM Part Number ‎43105
Product Dimensions ‎8.88 x 3.88 x 1.88 inches

3.6

11 Review
5 Star
77
4 Star
12
3 Star
3
2 Star
5
1 Star
3

Kirjutage oma arvustus

Teie e-posti ei avaldata. Kõik kohustuslikud väljad on tähistatud tähisega*

Scritto da: chkywuky
Light adp
Expensive
Scritto da: brian larson
Fit my Tacoma perfectly
It only took a few minutes to install.
Scritto da: Melissa Robinson
Works perfectly
Was a pleasure using this product fit exactly as expected and came with all mounting hardware great product and great company only wish it had some propaganda for my truck window
Scritto da: Steve
fits my 96 Honda
easy to connect
Scritto da: dig
no good installation instructions
I installed this product on a 04 Honda Element and it will need an extension to reach over the tail gate to a trailer. you will need to remove the right rear seat and unbolt the seat bracket. ( 3 bolts ) you also need to take the seat belt bolt out. take out the screws that hold the interior out and pop off the piece by the seat belt, rear strut plus a corner piece that would be behind the seat. I pried up the molding at the bottom of the door just enough to get the side piece clear. slowly and carefully work you way back from the side door to the rear, if things don't move you might have missed a screw. once the side piece is loose the plug is to the rear and lay the wire under the side piece into the spare tire well. Make sure the doors weatherstrip is on the outside of the plastic when you put it back together. Take your time and don't use too much force.
Scritto da: S. Vaden
Hopkins trailer taillight converter 43105
These adapters convert the five wire taillights of your car to four wire taillights of the trailer. The circuit is actually kind of complicated, but it is sealed inside the housing so it cannot get wet. The only problems I had installing this on the CRV were not related to the harness itself. You have to remove the inner plastic panel on the driver's side to get to the taillight connector, then you have to enlarge the hole in the bottom of the inner fender so that the taillight converter connector can fit through. I used a Unibit drill bit to enlarge the hole, and found a rubber grommet to fit so that it would not wear through the wires. The converter housing can be attached under the car with supplied tie wraps. These days ROHS requires the elimination of lead in connector platings. The plating used on the bullet connectors soon develops a white oxidation that makes it hard to plug the connectors together. The tin/lead platings were much better because they supplied some built-in lubrication. One step forward for mankind, two steps back. SV
Scritto da: Jesus O.
Good product
Facil de installed
Scritto da: crystal
Perfect for non led set up
Works as it should. However if you are running leds this is not the module you want to use. The module back feeds a little which will cause a led to light up when it shouldn’t where as a regular bulb won’t.
Scritto da: working class drone
Fits 2003-2004 honda element
fits perfectly into factory honda wiring harness. no cutting wires / splicing etc. hooked up the trailer and all the lights work flawlessly. i have read this does NOT fit the 2005+ honda element
Scritto da: Tanner
100% recommend!!!
Works as described, comes as described, plug n play
Scritto da: Vincent
Perfect!
Did wath is supose to. Perfect!

Seotud tooted

Avastage meie rahvusvaheline võrgustik

Saadame 28 riiki, üle 200 000 toote. Olge kursis, tellige uudiskiri.

Array