E-Z Lok SK20510 spiraalne keermestatud sisestuskomplekt, 304 roostevaba teras, keerme suurus nr 8-32, paigaldatud pikkus 0,164 (10 tk.)

Brand:E-Z LOK

3.7/5

67.69

E-Z Lok toodab keermestatud sisetükke metallile, plastile ja puidule. Ettevõtte peakontor asub Gardenas, CA.

KOMPLEKT KAASAB – Mugav komplekt sisaldab keermestatud metallile mõeldud sisestusi, puuri, STI-kraani, keermestatud sisestuste paigaldustööriista ja tangu murdmise tööriistu. RAKENDUSTEGA KASUTAMISEKS – Metallist keermestatud sisetükid on mõeldud kasutamiseks pehmete metallidega: alumiinium, malm, magneesium jne. ROOSTEVABA TERASTTRAAT – komplekt sisaldab roostevabast terasest keermestatud sisetükke, mis on korrosioonikindlad ja taluvad temperatuuri kuni 800°F. KIIRE PARANDAMINE KAHJUSTATUD KEEMI – selle spiraalse keermeparanduskomplektiga parandage kiiresti kahjustatud keermed või tugevdage keermestatud auke pehmetes metallides.
Country of Origin United Kingdom
Exterior Finish Plain
Fastener Type Insert
Item model number SK20510
Manufacturer E-Z LOK
Material Stainless Steel
Metal Type Stainless Steel
Package Dimensions 9.5 x 5.5 x 1.5 inches; 0.16 Ounces
Thread Size #8-32

3.7

4 Review
5 Star
81
4 Star
14
3 Star
0
2 Star
0
1 Star
6

Kirjutage oma arvustus

Teie e-posti ei avaldata. Kõik kohustuslikud väljad on tähistatud tähisega*

Scritto da: G. Burnett
Worked well - good instructions and quality pieces
Worked well - good instructions and quality pieces. No issues mounting the helicoil and it is holding up well.
Scritto da: June
The break away part of the coil is difficult to remove
The tab is hard to break off
Scritto da: Doug in Austin TX
Tiny threads in a Holley carburetor
I bought a used Holley 4150 carb off *bay and found that the threads had been stripped for the accelerator pump cover. They are tiny threads #8x32 and a little over 1/8" inch deep. This kit allowed me to drill to the correct depth and install the stainless coil type inserts. I ground off the pointed tip of the tap to allow me to get the threads all the way to the bottom of the hole. Worked perfectly and those threads will never pull out.
Scritto da: Jim
junk
the insertion should fit the inserts ie. threaded, I couldn't get one insert started using the insertion tool, the inserts kept distorting.

Seotud tooted

hot
3/5

€ 64.74

3/5

€ 64.74

Avastage meie rahvusvaheline võrgustik

Saadame 28 riiki, üle 200 000 toote. Olge kursis, tellige uudiskiri.

Array