CURT 56334 sõidukipoolne kohandatud 4 kontaktiga haagise juhtmestik, sobib Select Dodge Nitro, Jeep Liberty, must

Brand:CURT

3.7/5

114.99

Kui teie sõidukil pole haagise vedamiseks vajalikku juhtmestikku, on CURT kohandatud juhtmestik ideaalne lahendus. Kohandatud juhtmestik – mida nimetatakse ka T-pistikuks – on lihtne plug-and-play elektriseade, mis ühendatakse teie auto elektrisüsteemiga ja tagab standardse universaalse haagise juhtmestiku. Seda tehakse kahe või enama sõidukispetsiifilise OEM-iga ühilduva pistiku abil, mis ühendatakse tagatulede komplektiga, välistades vajaduse paigaldamise ajal lõikamiseks, liitmiseks ja jootmiseks. Kohandatud juhtmestikud on valmistatud sõidukipõhiselt ja kuigi need pole kõigi sõidukite jaoks saadaval, pakuvad need üht kiireimat, lihtsaimat ja turvalisemat viisi sõiduki pukseerimiseks. Sellel konkreetsel pistikühendusel on neljasuunaline lame pistikupesa ja see on loodud kohandatud juhtmestikuna, mis sobib teatud aastate Dodge Nitro ja Jeep Liberty mudelitele (sõiduki ühilduvuse kontrollimiseks vaadake rakenduse teavet). Kaasas on kõik vajalikud juhtmestiku komponendid, et luua usaldusväärne haagise juhtmestiku ühendus, samuti tolmukate, mis hoiab konnektori puhtana, kui seda ei kasutata. Teil on silme ees pilt oma järgmisest sihtkohast – võib-olla on see teie lemmikpüügikohas randuv paat, võib-olla on see kämping, kust avaneb vaade mõnele looduse meistriteosele, või võib-olla on see järgmine suur töökoht. Selle pildi reaalsuseks muutmine nõuab aga enamat kui lihtsalt unistamist. See nõuab tugevat ühendust ja õiget võimsust. CURTi kohandatud juhtmestik on valmistatud tööstuse kõige keerukama tehnoloogiaga ja on loodud hõlpsaks paigaldamiseks, pakkudes teile pikaajalist elektriühendust veokonksu seadistamiseks.

Ühikuid pole saadaval
TOLMUKATE. Pikaajalise kasutuse ja ilmastikukindluse tagamiseks on sellel 4-pooluselisel haagise valgustuse juhtmestikul kummist tolmukate. Kui seda ei kasutata, sobib see hõlpsasti 4-suunalise lamepistiku külge, kaitstes seda välistingimuste eest. USALDUSVÕIME. See 4-suunaline haagise juhtmestik on ehitatud pindpaigaldustehnoloogiaga. Seda tüüpi vooluringid toodavad vähem soojust, optimaalset valgustugevust ja vastupidavat jõudlust. SÕIDUKI SPETSIIFILINE. See järelturu haagise juhtmestik on mõeldud Dodge Nitro ja Jeep Liberty valitud aastate jaoks. STANDARDÜHENDUS. Seda pistikühendusega nelja tasapinnalise haagise juhtmestikku saab kasutada haagise tagatulede, piduritulede ja suunatulede ühendamiseks. 4-suunaline haagise tulede juhtmestik on populaarne paljudel haagistel, lisades teie sõidukile mitmekülgseid pukseerimisvõimalusi. LIHTNE PAIGALDADA. Ei mingit lõikamist! Ei mingit splaissimist! See haagise juhtmestiku komplekt ühendatakse teie sõiduki olemasoleva tehasejuhtmestikuga ja varustab selle standardse 4-kontaktilise haagise juhtmestiku pistikuga haagise ühendamiseks ja pukseerimiseks.
Brand CURT
Brand ‎CURT
Country of Origin ‎Philippines
Customer Reviews 4.7 4.7 out of 5 stars 281 ratings 4.7 out of 5 stars
Exterior ‎Painted
Item Dimensions LxWxH 9 x 6 x 3 inches
Item model number ‎56334
Item Weight ‎1.81 pounds
Manufacturer ‎CURT
Manufacturer Part Number ‎56334
Material Rubber
Model ‎Custom Wiring
OEM Part Number ‎56334
Product Dimensions ‎9 x 6 x 3 inches

3.7

11 Review
5 Star
80
4 Star
14
3 Star
3
2 Star
1
1 Star
2

Kirjutage oma arvustus

Teie e-posti ei avaldata. Kõik kohustuslikud väljad on tähistatud tähisega*

Scritto da: Christian Triplett
Quailty is great
I was a little hesitant about buying one of these because previous module installs didn’t work for me. However I bought this on a whim for my camper and it is has worked since day 1. It took a bit to install it cleanly. But I have had no issues with my trailer wiring since. It caught me off guard when I saw that the trailer turn signal will flash alternate to the car when the brakes are applied at the same time as the turn signal. But I’ve been running it for a few months without issue!
Scritto da: Marcos Santiago
Perfect fit
Installed in less then 30mins.
Scritto da: P K
Works as it should in 2009 Jeep Liberty, a bit of a challange to install (vehicle issues)
Trailer wiring harness was overall a good product for a good price. Installation was a bit of a challenge in several areas, but this is more of a Jeep/vehicle issue than the wiring harness fault. Not much room in the rear tail light areas for the 2 extra connectors. The instructions call for mounting the module under/outside the vehicle, but I mounted the electronic module inside the vehicle (in the jack compartment), and had to cut the factory rubber plugs where the vehicle wires go through the body to the tail lights in order to make these connections. Also, I had to remove several inside plastic body panels in order to fish the main power wire from the engine compartment to the rear of the vehicle. (HINT: Rubber plug in firewall where clutch rod would be if a manual tranny. No rod (easy access) if auto tranny.) One concern: I measured 0.3 volts from each of the 3 "Light" wires to ground even when the vehicle is not running. I'm sure this is something with the electronic switching of the module. A disconnect switch could be installed in the power wire when not using to eliminate this issue.
Scritto da: Gary G.
A Must-have accessory for DYI installers.
This harness was easy to install on my 2011 Liberty. There was plenty of room in the tail light recess for the extra plugs and wiring. The routing of the power line to the battery was a bit of a challenge to avoid the moving parts of the rear suspension and the exhaust system but it can be done with care. My only minor complaint is with the module. Even though I found a flat painted surface and cleaned it extremely well, the double sided mounting tape became loose within hours. I was able to secure the module using the mounting tab on the one end, but additional mounting tab(s) would be preferable.
Scritto da: Edward P.
Fit meant
Great price worked as it should and fast delivery
Scritto da: Lionel A Richard
Instructions clear but you do need some experience in automotive electrical wiring
Easy to install
Scritto da: Christa L. Barnes
Easy to install
Easy installation, clear directions
Scritto da: Jason J McKoy
Plug and play almost.
The product is great it sure beats the old days of splicing in the wires take your time and dont usse the double sided sticky tape to hold up the controller tou might get a 1/4 mile before it falls off self tap it in!
Scritto da: David P.
Easy to install
Product was easy to install. Trailer lights now work perfectly.
Scritto da: Cityslicker
Perfect wiring harness for my jeep
Delivery was on time. Plus easy installation and worked the first time.
Scritto da: Carrie
Wiring Harness Drained Battery
I hooked this up in August to my 2008 Jeep Liberty, which I only use to pull a trailer in the summer. After the Jeep sat for a couple of weeks at the end of the season, it wouldn't start. The Curt custom wiring harness 56334 is drawing constant power, and drained my battery (which was brand new in June). When I remove the fuse from the wire that goes to the unit, the battery is fine as it doesn't draw power, and the Jeep starts every time. I believe I have a faulty unit and would like it to be replaced as it should not draw power when not in use. I can't find any contact information for customer service. I am hoping that Curt Manufacturing will reach out to me to make this right.

Seotud tooted

Avastage meie rahvusvaheline võrgustik

Saadame 28 riiki, üle 200 000 toote. Olge kursis, tellige uudiskiri.

Array