CURT 55537 sõidukipoolne kohandatud 4 kontaktiga haagise juhtmestik, sobib valitud Dodge Caravan, Grand, Chrysler Town and Country

Name: CURT 55537 sõidukipoolne kohandatud 4 kontaktiga haagise juhtmestik, sobib valitud Dodge Caravan, Grand, Chrysler Town and Country
Brand: CURT
SKU: 0612314555376
Price: 73.67 EUR
Availability: InStock

Brand:CURT

3.6/5

€
73.67

Kui teie sõidukil pole haagise vedamiseks vajalikku juhtmestikku, on CURT kohandatud juhtmestik ideaalne lahendus. Kohandatud juhtmestik – mida nimetatakse ka T-pistikuks – on lihtne plug-and-play elektriseade, mis ühendatakse teie auto elektrisüsteemiga ja tagab standardse universaalse haagise juhtmestiku. Seda tehakse kahe või enama sõidukispetsiifilise OEM-iga ühilduva pistiku abil, mis ühendatakse tagatulede komplektiga, välistades vajaduse paigaldamise ajal lõikamiseks, liitmiseks ja jootmiseks. Kohandatud juhtmestikud on valmistatud sõidukipõhiselt ja kuigi need pole kõigi sõidukite jaoks saadaval, pakuvad need üht kiireimat, lihtsaimat ja turvalisemat viisi sõiduki pukseerimiseks. Sellel konkreetsel pistikühendusel on 4-suunaline lame pistikupesa ja see on mõeldud kohandatud juhtmestikuks, mis sobib teatud aastate Dodge Caravani, Dodge Grand Caravani ja Chrysler Town and Country jaoks (sõidukite ühilduvuse kontrollimiseks vaadake rakenduse teavet ). Kaasas on kõik vajalikud juhtmestiku komponendid, et luua usaldusväärne haagise juhtmestiku ühendus, samuti tolmukate, mis hoiab konnektori puhtana, kui seda ei kasutata. Teil on silme ees pilt oma järgmisest sihtkohast – võib-olla on see teie lemmikpüügikohas randuv paat, võib-olla on see kämping, kust avaneb vaade mõnele looduse meistriteosele, või võib-olla on see järgmine suur töökoht. Selle pildi reaalsuseks muutmine nõuab aga enamat kui lihtsalt unistamist. See nõuab tugevat ühendust ja õiget võimsust. CURTi kohandatud juhtmestik on valmistatud tööstuse kõige keerukama tehnoloogiaga ja on loodud hõlpsaks paigaldamiseks, pakkudes teile pikaajalist elektriühendust veokonksu seadistamiseks.

Summa

Lisa ostukorvi Osta kohe

EAN: 0612314555376

Kategooriad Autotooted, Emberkauba tarvikud, Trailerite tarvikud, Tarvikud, Pistikud,

TOLMUKATE. Pikaajalise kasutuse ja ilmastikukindluse tagamiseks on sellel 4-pooluselisel haagise valgustuse juhtmestikul kummist tolmukate. Kui seda ei kasutata, sobib see hõlpsasti 4-suunalise lamepistiku külge, kaitstes seda välistingimuste eest. LIHTNE HAARDE. Selle sõiduki pistikupesa ergonoomilise disainiga on haagise juhtmestiku ja haagise tulede ühendamine lihtne. Selle üla- ja alaosas on sakid, mis tagavad parema haarde haagisega ühendamisel või vooluvõrgust lahti ühendamisel. SÕIDUKISPETSIIFILINE. See järelturu haagise juhtmestik on mõeldud Dodge Caravani, Dodge Grand Caravani ja Chrysler Town and Country valitud aastate jaoks. STANDARDÜHENDUS. Seda pistikühendusega nelja tasapinnalise haagise juhtmestikku saab kasutada haagise tagatulede, piduritulede ja suunatulede ühendamiseks. 4-suunaline haagise tulede juhtmestik on populaarne paljudel haagistel, lisades teie sõidukile mitmekülgseid pukseerimisvõimalusi. LIHTNE PAIGALDADA. Ei mingit lõikamist! Ei mingit splaissimist! See haagise juhtmestiku komplekt ühendatakse teie sõiduki olemasoleva tehasejuhtmestikuga ja varustab selle standardse 4-kontaktilise haagise juhtmestiku pistikuga haagise ühendamiseks ja pukseerimiseks.

Brand	CURT
Brand	‎CURT
Country of Origin	‎USA
Customer Reviews	4.6 4.6 out of 5 stars 196 ratings 4.6 out of 5 stars
Exterior	‎Smooth
Is Discontinued By Manufacturer	‎No
Item Dimensions LxWxH	9 x 4 x 3 inches
Item model number	‎55537
Item Weight	0.31 Pounds
Item Weight	‎5 ounces
Manufacturer	‎Curt Manufacturing
Manufacturer Part Number	‎55537
Material	Rubber
Model	‎Custom Wiring
OEM Part Number	‎55537
Product Dimensions	‎9 x 4 x 3 inches

5 Star

4 Star

3 Star

2 Star

1 Star

Kirjutage oma arvustus

Teie e-posti ei avaldata. Kõik kohustuslikud väljad on tähistatud tähisega^*

Teie hinnang

Scritto da: Keith

Quick and easy

This was very easy to install, less than 20 minutes. Works great.

Scritto da: Tricker

Towing with lights is good

Read instructions, installed, lights up my trailer. Saved a bunch of money diy baby!

Scritto da: Alicia Mick

I wish there was a way to route it a diffrent way but had to come out the back when I use it because of the stow n go but it works fine just tuck it back in the trunk when not using

Scritto da: D. WALTER

Took a little maneuvering to install

When I bought this trailer light wiring harness for my 2005 Chrysler Town and Country, I thought it would be the same as with my 2005 Dodge Durango, and go on in a couple of minutes, but I was severely wrong. With this wiring harness, you have to push the ends of the wiring harness through a couple of prefab holes in your auto body. The problem with this is that there is insulation between the interior and exterior body panels, and the holes you need to push the wiring harness through can get pretty tight. The left side tail light was fairly easy with a larger hole in the body panel, I was able to put my hand in farther, and push the wiring harness easier. The Right side taillight was a little harder because the body panel hole on the interior was smaller, and a little lower than the exterior hole, so much more difficult to maneuver through the body. We ended up cutting the end of the right side wiring harness off, and running the wire through the panel, and then reattaching the harness end to the wire once it was through the body. Also, something I wasn't aware of with this harness is that the 4 pin connector is not maintained on the outside of the vehicle. This wiring harness stays inside the vehicle until you are ready to use it, and then you run the wires out through the back door whenever you're going to use it. The part I don't like about this harness is shutting the door on the wires. I know that there is weather stripping there, and it probably won't cut the wires by being closed on them, but I just feel it might degrade the life of the harness... Otherwise, so far so good. Decent wiring harness, somewhat difficult installation, but still functional, and decent quality.

Scritto da: Nicholas Maddox

Easy to install

Easiest install for any wiring project I’ve ever done!

Scritto da: John F

Quick use!!

Took about 5mins to install. I did not run it back through the body. I just ran the wires under the light assembly. Then pushed the wires inside the van 5mins tops. Didn't care for the ground wire. Had to use a drill Tel screw to the body. They could've tied that into the other white wires since the body harness for the lights is already grounded. Other than that no problems.

Scritto da: Keith J Rigden

Get it

Pretty easy to install in my 06 Grand Caravan. Routing to the passenger side requires you to fish it to the light cavity. Get a good look at what's going on there before you tie on. Wish the set was longer. Watched one video, but it was for another brand. This product is too short to route it their way, which is a little cleaner, but not a big deal. Only reason for knocking a star off. Worth every extra penny to not have splice anything!!

Scritto da: Ashish Desai

Very easy to install and worked with no issues

The harness is super easy to install on a 2005 dodge grand caravan sxt stow and go. Took about 20 minutes with no prior experience of knowing anything dodge or harness wiring. The self tapping ground screw worked instantly under the gamble and the length of excess wire is about 15 inches which is plenty to reach my trailer. Literally you can do this by watching a YouTube video on your phone and doing it same time. Definitely buy this kit and do not pay to get it installed ..you can do It yourself

Scritto da: Kevin from Calgary

Works well for my little trailer with LED lights.

Works well with my little trailer. Note that this kit does not contain a powered converter, so your trailer lights are powered from the vehicle's tail light wiring. If your small trailer has LED lights, this setup is fine. On my 2005 Grand Caravan, this kit will allow the trailer connector to extend outside the tailgate by a foot, or perhaps a little more. It takes a fair bit of cutting in the existing tail light wiring grommets for the hole to be large enough to push the connectors through to the space behind the taillights. That small tube of black silicon sealant is to reseal the grommet where you cut through. I used coil-style plastic wire loom to protect the wiring as it exits under the tailgate.

Scritto da: JP

Price was right, easy to install

Great price point, installed on an 04 caravan, took about an hr but never installed a trailer harness before. Good product!

Scritto da: Mr.Kent

works great.

no problems, works great.

Scritto da: Amazon Customer

... cable cannot be stored in the tire jack compartment like the other brand

It works with the exception that the plug is very tight and the cable cannot be stored in the tire jack compartment like the other brand. Minor problems. Seems to work OK.

Scritto da: Dompti

????

Parfait mais je l’es retourner je n’avais plus besoin.